This chapter is not needed for surveys in PPK mode - go to chapter 8.
- Prepare the correction source:
- the D-RTK 2 base station (Matrice 350 RTK and Matrice 400) or D-RTK 3 (Matrice 400) - set it up according to the rules in chapter 10.3;
- or an account in a reference station network (NTRIP) and an internet connection of the remote controller via Wi-Fi or DJI Cellular Dongle.
- In DJI Pilot 2, open the camera view, tap "..." and select RTK.
- Enable RTK positioning and select the service type: D-RTK 2 Mobile Station, D-RTK 3 or Custom Network RTK.
- For a network, enter the NTRIP parameters (address, port, account, password, mount point) and tap Save. The remote controller must remain on and connected to the internet for the entire flight.
- Wait for the FIX status in the positioning status table.
Start the survey only with the FIX status.
If RTK is enabled but corrections are not received, the drone will not take off. Disable RTK when not in use.