5.1 General Installation Procedure
Install the equipment in conditions without dust, precipitation and strong wind. In bad weather, perform the installation indoors, in a vehicle or under a shelter so that moisture and dust do not get on the X-Port connector contacts and the lens.
- Remove the camera with the gimbal from the case.
- Remove the lens cap and check that the lens is clean.
- Install the gimbal with the camera on the drone Skyport connector (see chapter 5.2).
- Close the case with at least one latch.
Do not leave the case open: it is usually located near the takeoff site, and dirt, dust and moisture can get inside, causing corrosion and equipment damage.
5.2 Installation on DJI Matrice 400 / 350 RTK
- Remove the protective covers from the gimbal X-Port connector and the drone Skyport connector.
- Insert the gimbal into the Skyport connector and rotate it until it clicks lightly. The gimbal is locked.
- Turn on the drone and wait for the gimbal and camera to initialize.
- In the DJI Pilot 2 app, open the gimbal settings and perform the gimbal auto calibration.
Perform the gimbal auto calibration on a level, stationary surface without vibration. It is performed once when you receive the equipment.
Removal is performed in reverse order: press the button on the Skyport connector holder and rotate the gimbal in the opposite direction.