- TOPODRONE SLAM 100 is high-precision equipment; handle it with care and avoid impacts!!!
- After use, put it in the transport case as soon as possible.
- The dark part of the LiDAR sensor is the emission zone, so avoid friction and collisions between this module and hard objects.
- When taking the equipment out of the box, use both hands: hold the handle with one hand and the sensor with the other, but do not squeeze the scanning area or pull it out with force.
- When inserting the memory card, make sure it is not locked and has enough space for recording data.
- During transport, put the batteries in the transport case to avoid impacts with hard objects or contact with liquids.
- Pay attention to the polarity of the battery terminals when charging and using it.
- Be careful when removing the batteries from the equipment so as not to damage them if they fall.
- During data collection, hold the scanner in front of you in the direction of travel with the sensor up, and do not interfere with its rotation by touching it or other movements.
- There are three groups of camera lenses on the front of the body; avoid friction or collisions with hard objects.
- Power on
- After a long press of about 3 seconds, the indicator turns green, and after about 40 seconds the sensor starts rotating and enters standby mode;
- After a short press, the indicator starts blinking, which means the device has started collecting data. Stay still for about 10 seconds before moving forward so that
- TOPODRONE SLAM 100 can collect data about the environment at the starting point;
- When data collection is complete, press the button to stop the equipment; the green indicator lights up;
- To switch the device off, hold the power button for 3 seconds until the green indicator turns blue and the laser stops rotating;
Pay attention to the battery level. The yellow indicator lights up when the battery is low, so charge the equipment after field work.
Field work precautions
Was this article helpful?